Adtran NetVanta 300 Series Bedienungsanleitung PDF herunterladen (Seite 25)

NetVanta 300 Series Hardware Installation Guide Unit Installation

Wall Mounting

Figure 5. Wall Mounting the NetVanta 300 Series Unit

Instructions for Wall Mounting

Step Action

1 Decide on a location for the NetVanta 300 Series unit. Keep in mind that the unit needs to be

mounted at or below eye-level so that the LEDs are viewable.

2 Prepare the mounting surface by attaching a board (typically plywood, 3/ 4-inch to 1-inch thick)

to a wall stud.

Important! Mounting to a stud ensures stability. Using sheetrock anchors may not

provide sufficient long-term stability.

3 Install two #8 PAN headscrews (1 1/ 2-inch or greater in length) wood screws into the mounted

board, following these guidelines and referring to Figure 5:

• Screws should be spaced horizontally, approximately 5 inches apart. Find exact positioning

by using the location of the two keyed insets on the bottom of the NetVanta 300 Series unit

as a guide.

• Screws should be horizontally level with each other.

• Leave approximately 1/4 inch of the screws protruding from the board to allow the heads of

the screws to slide into place in the unit’s keyed insets.

4 Slide the keyed insets on the bottom of the unit’s chassis securely onto the screws.

5 Proceed to the steps given in Getting Started on page 26.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Keine Kommentare

Adtran NetVanta 300 Series Bedienungsanleitung Seite 25