ADTRAN 12804108L1B Bedienerhandbuch PDF herunterladen (Seite 36)

Section 4 Network Turnup Procedure TRACER 4108/4208 System Manual

1. INTRODUCTION

This section discusses the installation process of the TRACER 4108/4208 system.

2. TOOLS REQUIRED

The tools required for the installation of the TRACER 4108/4208 are:

• VT100 terminal or PC with terminal emulation software

• RS-232 (DB-25 male for TRACER 4108/4208) cable for connecting to terminal

3. UNPACK AND INSPECT THE SYSTEM

Each TRACER 4108/4208 is shipped in its own cardboard shipping carton. Open each carton carefully and

avoid deep penetration into the carton with sharp objects.

After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in

transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Customer

Service, Product Support Information, and Training information in the front of this manual).

Contents of ADTRAN Shipment

Your ADTRAN shipment includes the following items:

• TRACER 4108/4208 Unit

• TRACER 4108/4208 Documentation CD

• Eight T1 Crossover (RJ-48 to RJ-48) Cables

• Eight T1 Straight Through (RJ-48 to RJ-48) Cables

Customer Provides

The following items are necessary for the installation of the TRACER 4108/4208 system and are not

provided by ADTRAN:

• 21 to 60 VDC power source (or AC adapter available from ADTRAN P/N 1280650L1), either polarity

referenced to ground

• Antenna and mounting hardware

• Antenna feedline cable

• Lightning arrestors

• Weatherproofing kits for antenna installation

Changes or modifications not expressly approved by ADTRAN could void the user’s

authority to operate the equipment.

To prevent electrical shock, do not install equipment in a wet location or during a lightning

storm.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

Keine Kommentare

ADTRAN 12804108L1B Bedienerhandbuch Seite 36