ADTRAN 850 Bedienerhandbuch PDF herunterladen (Seite 202)

Section 4 User Interface Guide Total Access 850 System Manual

2. Configuring the Layer 2 Protocol

For more details on the configuration parameters discussed in this section, refer to the following pages:

Layer 2 ATM Network T1 menus beginning on page 129

Press <ENTER> on the TANDEM [+] option to view the TANDEM options if

the port mode is set to T

ANDEM (E&M).

Set the CONVERSION MODE of the port to either LOOP START or GROUND

TART.

13 Set the SUPERVISION of the port to either IMMEDIATE or WINK.

Be sure to set the TANDEM options for each port set to TANDEM E&M.

Layer 2 Protocol Configuration – T1 Interface

Step Action

From the main menu, select L2 PROTOCOL and press <ENTER>.

Use the arrow keys to select the PROTOCOL field for the T1 interface. Press

NTER>. Select ATM from the list of available protocols.

Use the arrow keys to select the CONFIG menu for the T1 interface and press

NTER>.

4 Highlight the ATM CONFIG menu for the T1 interface and press <ENTER>.

5 Enter the IDLE CELLS format for your network.

6 Set DATA SCRAMBLING appropriately for your network.

Back all the way out to one level to the PVC CONFIG menu, and press <ENTER>.

Enter the VPI and VCI values for communicating with that Gateway. (From this

menu, the appropriate Voice information for working with the Voice Gateway is

entered by selecting V

OICE under the CONNECTION field.)

FXS Interface Setup Instructions (Continued)

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 291 292

Keine Kommentare

ADTRAN 850 Bedienerhandbuch Seite 202