ADTRAN NetVanta 4305 Installationsanleitung Seite 39

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 53
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 38
NetVanta 4305 Hardware Installation Guide Unit Installation
61200890L1-34B © 2004 ADTRAN, Inc. 39
Mounting Options
The NetVanta 4305 may be installed in a tabletop, wall mount, or 19-inch rack mount configuration. The
following sections provide step-by-step instructions for rack mounting and wall mounting.
Rack Mounting NetVanta 4305
The NetVanta 4305 is housed in a 1U high, rack-mountable chassis which can be installed into 19-inch
equipment racks. Follow these steps to mount the NetVanta 4305 into a rack:
Wall Mounting NetVanta 4305
If you have purchased the VPN Accelerator Card, install it first. See Installing the
NetVanta VPN Accelerator Card (1202368L1) on page 43.
Instructions for Rack Mounting NetVanta
Step Action
1
Position the NetVanta 4305 in a stationary equipment rack. This unit takes up 1U of space. To
allow proper grounding, scrape the paint from the rack around the mounting holes where the
NetVanta 4305 will be positioned.
2 Have someone else hold the unit in position as you install two mounting bolts through the unit’s
brackets and into the equipment rack using a #2 Phillip’s screwdriver.
3 Proceed to the steps given in Supplying Power to the Unit on page 40.
Be careful not to upset the stability of the equipment mounting rack when installing this
product.
Instructions for Wall Mounting NetVanta 4305
Step Action
1
Remove the mounting ears. Rotate them 90
o
so that the portion of the bracket with the
mounting holes is flush with the bottom of the chassis, and reattach them to the chassis.
2 Decide on a location for the NetVanta 4305. Keep in mind that the unit needs to be mounted at
or below eye-level so that the LEDs are viewable. Important! Mount the chassis with LEDs
facing to the side (not facing up or down).
Warning! Do not mount the chassis with the right-side fans facing down.
3 Prepare the mounting surface by attaching a board (typically plywood, 3/ 4" to 1" thick) to a wall
stud. Important! Mounting to a stud ensures stability. Using sheetrock anchors may not
provide sufficient long-term stability.
Seitenansicht 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 52 53

Kommentare zu diesen Handbüchern

Keine Kommentare