Adtran MX2800 M13 Bedienungsanleitung PDF herunterladen (Seite 129)

MX2800 M13 Multiplexer User Manual Transaction Language 1 (TL1), Section 9

61200290L1-1G 9-5

The MX2800 specifically uses quoted line(s) in REPT-ALM and REPT-EVT Autonomous messages. The

REPT-ALM message has the following quoted line format:

<aid>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,<locn>…

The NTFCNCDE field contains one of the following values:

• CL indicates alarm cleared.

• TC indicates transient condition.

• MN indicates minor.

• MJ indicates major.

• CR indicates critical.

The

REPT-EVT message has the following quoted line format:

<aid>:<ntfcncde>,<condeff>,<srveff>,<ocrdat>,<ocrtm>,<locn>…

The CONDEFF field will contain one of the following values:

• CL indicates standing condition cleared.

• SC indicates standing condition raised.

• TC indicates transient condition.

For possible CONDTYPE codes for both REPT-ALM

and REPT-EVT quoted lines, see the condition types

listed in Tab le 9-3 on page 9-12 and Tab le 9-4 on page 9-16, respectively.

Refer to the section TL1 Autonomous Messages on page 9-11 for a list of Autonomous messages currently

supported by the MX2800.

4. TL1 COMMANDS

As stated in TL1 Messages on page 9-3, the general format for a TL1 command is as follows:

<verb>[-<mod1>[-<mod2>]]:<tid>:<aid>:<ctag>:<general block>:<keyword

block>: <state block>;

Areas of concentration for TL1 support in the MX2800 include session initiation, session termination, and

system event reporting. Table 9-2 lists the commands currently supported by the MX2800.

NOTE

The Target ID (

tid) is the same as the Unit ID. Refer to the Unit ID on

page 3-36.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 199 200

Keine Kommentare

Adtran MX2800 M13 Bedienungsanleitung Seite 129