ADTRAN 1500 Spezifikationen

®Section 61180019L1-5AIssue 1, May 2004CLEI Code: VAM5500F_ _61180019L1-5A 1Trademarks: Any brand names and product names included in this documen

10 Issue 1, May 2004 61180019L1-5A• BANK (Bank System Major) •PWRIn the T1 Mapping mode, the Total Access 1500 separately monitors the performance

61180019L1-5A Issue 1, May 2004 11NOTEOmit step 4 if the alarmed piece of equipmenthas its own source of –48 VDC and does notneed the –48 VDC feed

12 Issue 1, May 2004 61180019L1-5AFigure 9. RS-485 WiringClk inSe c+ -Clk outSe c+ -Clk inPr i+ -Clk outPr i+ -Aux3 Aux4+ -Loc

61180019L1-5A Issue 1, May 2004 13NOTEThe CO X.25 network administrator mustconfigure the X.25 switch for the Total Access1500 19-Inch Chassis, ac

14 Issue 1, May 2004 61180019L1-5A5. WARRANTY AND CUSTOMER SERVICEADTRAN will replace or repair this product within the warranty period if it does

2 Issue 1, May 2004 61180019L1-5AThe Total Access 1500 19-Inch Chassis is 19-inches wide by 3.50-inches high by 10.75 inches deep, and the chassis

61180019L1-5A Issue 1, May 2004 3This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This

4 Issue 1, May 2004 61180019L1-5AThe recommended ways to mount the chassis are as follows:• Flush-mount: To flush-mount a Total Access 1500 19-Inc

61180019L1-5A Issue 1, May 2004 5All permanent connections to the Total Access 1500 19-Inch Chassis are made on the backplane. Figure 4 is a detai

6 Issue 1, May 2004 61180019L1-5AFigure 5. Backplane and Pinouts RS-232 (J34) Pin Number Description 1 Frame Gr

61180019L1-5A Issue 1, May 2004 75. Using a screwdriver appropriate for the fuse and alarm panel terminals, and a straight slot or phillips screwd

8 Issue 1, May 2004 61180019L1-5A6. Tie the clock source wire neatly to the frame.7. Set SW3 to the IN position (SW3 is the center switch in the t

61180019L1-5A Issue 1, May 2004 9Up to 14 dual LIU systems or 28 single LIU systems may be daisy chained to a single output from the timing source