3 61180001L1-5B Section 61180001L1-5 Issue 2
NOTE
To prevent ESD events when handling this
equipment, all personnel should utilize ESD shoes
or wrist straps, or an ESD flooring must be
present.
Compliance Codes
This product is intended to be installed in products
providing a Type “B” or “E” enclosure, and in a
Restricted Access Location. See Table 1.
Tools Required
The required tools for the Total Access 1500
installation are:
• Wire-wrap tool
• #2 Phillips-head screwdriver
• #1 Phillips-head screwdriver
• Straight-slot-head screwdriver
• Multimeter
• Crimping tool for power lugs
• Wire strippers
• Side cutters
• 3/16-inch wrench
Material that should be on hand:
• Four screws for mounting each Total Access 1500
shelf to the rack
• Shielded 2-wire, twisted pair cross-connect wire
with drain, such as AT&T P7 wire
• Insulated wire for power connections, in colors
dictated by your CO for battery to the Total
Access 1500 shelf and return
• Insulated wire for frame ground
• Lugs for the power wire and Frame Ground
connection
WARNING
To prevent electrical shock, do not install
equipment in a wet location or during a lightning
storm.
CAUTION
Electronic modules can be damaged by static
electrical discharge. Before handling modules,
wear an antistatic discharge wrist strap to prevent
damage to electronic components. Place modules
in antistatic packing material when transporting
or storing. When working on modules, always
place them on an approved antistatic mat that is
electrically grounded.
Unpack and Inspect the Shelf
Each Total Access 1500 shelf is shipped in its own
cardboard shipping carton unless it was ordered as a
fully racked system. Open each carton carefully and
avoid deep penetration into the carton with sharp
objects.
After unpacking the unit, inspect it for damage. If the
equipment has been damaged, file a claim with the
carrier and then contact ADTRAN. See Warranty and
Customer Service section.
Mounting the Shelf
Mounting Bracket Orientation
The Total Access 1500 shelf comes with mounting
brackets that can be mounted with the flanges facing
forward or backward in two different locations on the
shelf sides. Therefore, the rack can be flush-mounted
or mid-mounted. Attaching the mounting brackets to
the shelf requires four screws on each side, and are
supplied with the unit.
The following are the recommended ways to mount the
shelf:
1. Flush-mounting: For flush-mounting on the rack,
use a #2 Phillips-head screwdriver and attach the
mounting brackets with the flanges facing
rearward on the rear mounting holes.
2. Mid-mounting: For mid-mounting, use a #2
Phillips-head screwdriver and attach the mounting
brackets with the flanges facing forward on the
front mounting holes.
Installing the Shelf
After attaching the mounting brackets to the Total
Access 1500 shelf sides, use the appropriate screws for
your Central Office rack type and mount the shelf in
the rack as follows:
Code Input Output
Power Code (PC) F C
Telecommunication Code (TC) X X
Installation Code (IC) B –
Table 1. Compliance Codes
(60 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern