ADTRAN 600R Spezifikationen PDF herunterladen (Seite 53)

Total Access 600R System Manual Section 4 User Interface Guide

The remaining Syslog parameters have the following level choices:

FATAL (Highest priority)

ALERT

CRITICAL

ERROR

WA RNI NG

NOTICE

INFO

DEBUG (Lowest priority)

Every log message generated by the IAD has a reporting level priority. If the message priority is lower than

the configured priority for the destination log, the message is not forwarded to the syslog daemon. See

RFC3164: The BSD Syslog Protocol. The lower the log level, the more messages that will be generated.

Setting reporting levels to DEBUG may negatively affect the performance of the IAD, including causing

the IAD to reset.

SYSLOG using Terminal Mode

Another option for configuring syslog is using the terminal mode command log dump <logname>. The

logname must be all CAPS and be one of the following names:

FATAL

ALERT

CRITICAL

ERROR

WA RNI NG

NOTICE

INFO

DEBUG

The command will dump all messages for the indicated log (

ALL LEVEL shows all log messages) stored in

the internal log buffer to the command line display.

SYSTEM CONFIG > SYSLOG > ALL LEVEL

This entry allows setting the default reporting level for all log entries. If ALL LEVEL is a lower priority than

the individual log entry level,

ALL LEVEL overrides the individual log reporting level.

SYSTEM CONFIG > SYSLOG > KERNEL LEVEL

Minimum required level for sending KERNEL log messages.

ADTRAN recommends using DEBUG for only short periods of time for debug purposes

only.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 195 196

Keine Kommentare

ADTRAN 600R Spezifikationen Seite 53