ADTRAN 600R Spezifikationen PDF herunterladen (Seite 93)

Total Access 600R System Manual Section 4 User Interface Guide

ROUTER > CONFIG > ROUTES > STATIC ROUTES

Use this menu to enter static routes to other networks.

ROUTER > CONFIG > DHCP SERVER

Use this menu to set up the DHCP server.

ROUTER > CONFIG > DHCP SERVER > DHCP MODE

When set to ON, the unit acts as a DHCP server and will dynamically assign IP, network mask, default

gateway, and DNS addresses to any device which transmits a broadcast DHCP request. The addresses

assigned are based on the unit’s own IP address and will be within the same network. Default is

OFF.

Displays the index number in the static route table.

ACTIVE

Adds this static route entry to the IP routing table when set to YES and removes it (if it was previously

added) if set to

NO. Default is NO.

IP ADDRESS

The IP address of the host or network address of the device being routed to. Default is 0.0.0.0.

SUBNET MASK

Determines the bits in the previous IP address that are used. If this is to be a host route, it must be set

to all ones (255.255.255.255). Default is

0.0.0.0.

GATEWAY

The IP address of the router to receive the forwarded IP packet. Default is 0.0.0.0.

OPS

The number of router hops required to get to the network or host. Maximum distance is 16 hops.

Default is

PRIVATE

When set to NO, the unit will advertise this static route using RIP. Setting to YES means that the route

is kept private. Default is

NO.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 195 196

Keine Kommentare

ADTRAN 600R Spezifikationen Seite 93