ADTRAN 1204006L1 Bedienungsanleitung PDF herunterladen (Seite 87)

Chapter 7. DTE Port Configuration

61200208L1-1 Express 5210 User Manual 7-11

LLC2 SSAP

Defines a point-to-point connection on the network. For an SDLC

connection, the SSAP of one Express 5210 should match the DSAP

on the other Express 5210. The value of this parameter must be in

hex and in increments of four beginning with 04.

LLC2 DSAP

Defines a point-to-point connection on the network. For an SDLC

connection, the DSAP of one Express 5210 should match the SSAP

of the other Express 5210. The value of this parameter must be in

hex and in increments of four beginning with 04. See the section

SNA/SDLC with Local Spoofing on page 5-1 for a configuration

example which demonstrates the SSAP and DSAP arrangement.

Outgoing DLCI (OUT DLCI)

Enter the DLCI address that identifies the virtual circuit used to

make the SDLC connection.

Transparent BOP Protocol (TRANS BOP)

RANSPARENT

BOP

is a synchronous mode which can accept any

HDLC-like protocol as input. This setting allows the Express 5210

to connect to devices even if the Express 5210 does not understand

their protocol addressing and controlling techniques. The

Express 5210 becomes transparent to the data link layer protocol

and provides end-to-end connectivity between two HDLC-like

devices. See Figure 7-6 for the

RANSPARENT

BOP

menu tree.

When building or editing an

DDRESS

ABLE

, you must use the Next,

Prev, Add, and Delete keys on the front panel (described in the chart on

page page 3-9), or the

Insert and Delete functions of the terminal inter-

face (described in the chart on page 3-7).

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 202 203

Keine Kommentare

ADTRAN 1204006L1 Bedienungsanleitung Seite 87