ADTRAN MX410 Spezifikationen PDF herunterladen (Seite 41)

MX410 Data Path Block Diagram

61189500L1-1F 3-19

Setup

First, connect the RS-232 craft port on the other equipment to the MX410 terminal server

port. For more information, refer to “Terminal Server Ports” on page 4-8.

The default settings for the terminal server ports are 9600 bps and 8 data bits with no parity

(see Figure 3-24). These settings must match the craft port settings of the other equipment for

the application to work. Baud Rate can be changed in the MX410 Terminal Server menus

under Provisioning.

Figure 3-24. Terminal Server Port Menu

Then, establish a Telnet session to the MX410 with the port number for the particular port to

access the other equipment. The default IP address for the MX410 is 192.168.100.1 with a

subnet mask of 255.255.0.0. The port numbers default to 2023, 2024, 2025, and 2026,

respectively, for each of the four ports. Once the session is established, the default username

for each port is “port #” (where # is the number of the port) and the default password is

“password”.

For Ethernet based devices, simply assign a static IP address to the other equipment (or

enable the DHCP server to provide one) and connect its Ethernet port to one of the four switch

ports (Ethernet 1 - 4) on the front panel for the MX410. Refer to “DHCP Server Menu” on

page 5-40 for more information about DHCP servers.

MX410 MM/DD/YY HH:MM

Active Alarms: CRITICAL ID: MX410

Terminal Server Port 1

1 - Terminal State : Enabled

2 - Baud Rate : 9600

3 - Telnet Port Number : 2023

4 - Security : Enabled

5 - Username : port 1

6 - Password : password

Selection : '?' - System Help Screen

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 133 134

Keine Kommentare

ADTRAN MX410 Spezifikationen Seite 41