ADTRAN ATLAS 550 Bedienungsanleitung PDF herunterladen (Seite 148)

Chapter 11. Dial Plan

11-6 ATLAS 550 User Manual 61200305L1-1

SER

ERM

This menu allows you to define option parameters for ports which termi-

nate a connection from user equipment. In this case, ATLAS 550 is acting as

the Network.

SLOT/SVC

Write security: 3; Read security: 5

Selects the ATLAS 550 slot and port that terminate a User connection. (The

user selects from a list of option modules/ports.)

PORT/PEP

Write security: 3; Read security: 5

Selects the ATLAS 550 slot that terminates a User connection.

SIG

Write security: 3; Read security: 5

Defines the type ofsignaling being used for this connection (endpoint).

Select RBS for a T1 using Robbed Bit Signaling or PRI for a Primary Rate

ISDN interface. You only need to set signaling if a T1/PRI is selected as the

Slot/Port type.

IN#ACCEPT

Write security: 3; Read security: 5

Defines the parameters for incoming calls that ATLAS 550 accepts from the

Network.

ID Write security: 3 Read security: 5

Identifies the ID of the call sources from which this endpoint accepts calls.

This field simplifies the creation of a D

IAL

LAN

in applications where the

criterion for switching calls to a certain endpoint is a function of which end-

In applications where two ATLAS 550 units are used in a point-to-

point configuration, a port in the ATLAS 550 at one end acts as the

Network (setup asa Usertermination), while the ATLAS 550 at the

opposite end terminates a Network connection (Network

Termination).

Morethanone endpointmay beassociatedwith a particularport. If

a T1 port is connected to a channel bank with analog voice cards,

each DS0 or group of DS0s may have a different phone number.

These numbers constitute multiple endpoints over a single physical

port.

One HDLC resource is used by each PRI or each Packet Endpoint.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 261 262

Keine Kommentare

ADTRAN ATLAS 550 Bedienungsanleitung Seite 148