ADTRAN 1204006L1 Bedienungsanleitung PDF herunterladen (Seite 69)

61200.175L1-1 FSU 5622 ESP User Manual 53

Chapter 6. DTE Port Configuration

Setting the IP address to 0.0.0.0 and setting the Mng DLCI to a

value not used by the attached frame relay device disables this

feature.

IP Address (IP ADDRESS)

Enter the FSU 5622 ESP IP address. Each port capable of carry-

ing IP traffic has its own unique IP address. See the previous

section, Guidelines for Configuring IP Addr, Subnet Mask, and Mng

DLCI, for more information.

Subnet Mask

Enter the subnet number assigned to the network formed by the

FSU 5622 ESP and the other FRAD/routers across the frame

relay network. See the section, Guidelines for Configuring IP

Addr, Subnet Mask, and Mng DLCI, for more information.

Management DLCI (MNG DLCI)

Enter the management data link connection identifier. The

Management DLCI is a special DLCI used between the attached

DTE device and the FSU 5622 ESP to carry SNMP and TELNET

packets to/from the FSU 5622 ESP on the DTE port. See the

section, Guidelines for Configuring IP Addr, Subnet Mask, and Mng

DLCI, for more information.

Protocol Address Table

DTE Port DLCI (PRT DLCI)

Enter the DTE port DLCI into the Protocol Address Table,

mapping it to the corresponding Network DLCI. If address

translation is not required, set to the value of the corresponding

network DLCI element.

Network DLCI (NET DLCI)

Enter the network port DLCI into the Protocol Address Table,

mapping it to the corresponding DTE Port DLCI. This element

should contain DLCI addresses obtained from the service

provider.

Edit Next Entry (NEXT key on front panel)

Edit the next entry in the address table.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 174 175

Keine Kommentare

ADTRAN 1204006L1 Bedienungsanleitung Seite 69