ADTRAN 1204006L1 Bedienungsanleitung PDF herunterladen (Seite 85)

61200.175L1-1 FSU 5622 ESP User Manual 69

Chapter 6. DTE Port Configuration

Synchronous Bit Rate (RATE)

Select the operating speed of the DTE interface. The selections

are 2400, 4800, and 9600 bps and 19.2, 38.4, 56, 64, 112, 128, 168,

192, 224, 256, 280, 320, 384, 448, and 512 kbps.

Speed selections made for the Network Port affect the choices available

for the DTE ports.

Transmit Idle Code (IDLE)

Enable the FSU 5622 ESP to transmit flags or all ones.

Hardware Flow Control (HDW FLOW CTRL)

When enabled, the FSU 5622 ESP varies the transmit clock rate to

temporarily limit the transmit data rate to the FSU 5622 ESP.

Protocol Options

Protocol options are not available when the PPP Synchronous

protocol is enabled.

Protocol Address Table

IP Address (IP ADDRESS)

Enter the internet protocol (IP) address assigned to the FSU 5622

ESP for the DTE port.

Subnet Mask

Enter the subnet number assigned to the network formed by the

FSU 5622 ESP and the Peer PPP station.

Peer IP Address (PEER IP ADDR)

Enter the IP address of the attached PPP device.

Transmit RIP Packets (TX RIP)

Enable or disable the FSU 5622 ESP's transmission of routing

information protocol (RIP) messages. RIP broadcasts occur in 60

second intervals, advertising network addresses to the Peer PPP

device. Routing tables are generated from these broadcasts.

Process Received Packets (RIP REPLY)

Enable or disable the FSU 5622 ESP's reply to the request from

the Peer PPP device to issue RIP messages.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 174 175

Keine Kommentare

ADTRAN 1204006L1 Bedienungsanleitung Seite 85