ADTRAN MX410 Spezifikationen PDF herunterladen (Seite 30)

MX410/MX412 System Manual

3-8 61189500L1-1F

Setup

Connect the DS1 from which the DS0s will be dropped to the DS1 1 RJ. Connect the other

DS1 to which the DS0s will be inserted to the DS1 2 RJ. Connect the other DS1s using the

other RJ connectors on the front panel. For more information, refer to “DS1 Ports” on page 4-6

Starting from the default mapping the DS0s can be dropped and inserted using the Quick

Setup menu (see Figure 5-39 on page 5-52). Select each port (PPP or V.35) to which a DS0

needs to be dropped from the incoming DS1. For each port select the DS0(s) in DS1 1 to be

dropped to that port. Then, select each port and DS0 that needs to be inserted into the other

DS1. For each DS0 to be inserted, select the DS0 in DS1 2 to insert that DS0. Using the

Cross-Connect Mapping menu, select each DS0 that is to be dropped to other DS1 ports as

well. Select the Map Multiple DS0s option, then select the range of DS0 and DS1 1 to be

dropped to DS1 2 and enable Robbed Bit Signaling if applicable.

For each DS0 dropped out of the incoming DS1 (DS1 1 in this example), that does not have a

DS0 dropped or inserted into the corresponding DS0 in the other DS1 (DS1 2 in this example),

map the remaining DS0s to continue the data downstream. Any unmapped DS0 will transmit

all ones.

The following six figures show an example of setting up a drop and insert application. Figure

3-8 shows the Quick Setup menu before any DS0s have been dropped.

Figure 3-8. Quick Setup Menu

MX410 MM/DD/YY HH:MM

Active Alarms: CRITICAL MINOR ID: MX410

Quick Setup

Ports

1 - PPPs

PPP 1 = DS1 4 DS0 #1

2 - V.35 =

System

3 - System ID

4 - IP Address : 192.168.100.1

Subnet Mask : 255.255.0.0

5 - Default Gateway : 192.168.1.1

6 - Date

7 - Time 8 - Cross-Connect Mapping

Selection : '?' - System Help Screen

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 133 134

Keine Kommentare

ADTRAN MX410 Spezifikationen Seite 30