ADTRAN MX410 Spezifikationen PDF herunterladen (Seite 36)

MX410/MX412 System Manual

3-14 61189500L1-1F

Setup

Connect the DS1 from which the DS0s will be dropped to the DS1 1 RJ Connector. Connect

the other DS1s to DS1, 2, 3, and 4 RJ Connectors. For more information, refer to “DS1 Ports”

on page 4-6.

Starting from the default mapping the DS0s can be mapped using the Quick Setup menu

shown in Figure 3-16. Select each port to which a DS0 needs to be dropped from the incoming

DS1. For each port select the DS0(s) in DS1 1 to be dropped to that port. Using the Cross-

Connect Mapping menu, select each DS0 that is to be mapped from other DS1 ports as well. If

robbed bit signaling is needed, select the Map Multiple DS0’s option and then select the range

of DS0 and DS1 1 to be dropped to DS1 2 and enable Robbed Bit Signaling.

For an integrated wireless access device application, map DS0s to the corresponding DS0 in

the other DS1 (DS1, 2, 3, and 4 in this example). For a grooming application, each DS0

dropped out of the incoming DS1 (DS1 1 in this example), that does not have a DS0 dropped

or inserted into the corresponding DS0 in the other DS1 (DS1 2, 3, and 4 in this example),

map the groomed DS0s to continue the data downstream. Any unmapped DS0 will transmit

all ones.

The following six figures show an example of setting up an integrated wireless access device or

grooming application. Figure 3-16 shows the Quick Setup menu before any DS0s have been

dropped.

Figure 3-16. Quick Setup Menu

MX410 MM/DD/YY HH:MM

Active Alarms: CRITICAL MINOR ID: MX410

Quick Setup

Ports

1 - PPPs

2 - V.35 =

System

3 - System ID

4 - IP Address : 192.168.100.1

Subnet Mask : 255.255.0.0

5 - Default Gateway : 192.168.1.1

6 - Date

7 - Time 8 - Cross-Connect Mapping

Selection : '?' - System Help Screen

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 133 134

Keine Kommentare

ADTRAN MX410 Spezifikationen Seite 36