ADTRAN TA 544 Bedienerhandbuch PDF herunterladen (Seite 110)

Section 5 DLP-4 Total Access 544R System Manual

1. Connect the unit to your VT100 system (details found in DLP-1, Connecting the Terminal or PC to the

CRAFT Port).

2. Log in to the system with maximum rights (details for logging in are in DLP-2 and

DLP-3).

3. From the R

OUTER/CONFIG/INTERFACES (ETH) menu, select the SETUP option and press <Enter>.

4. Select the P

RIMARY IP option and press <Enter>. Select IP ADDRESS and press <Enter>.

Enter the appropriate IP address.

5. From the ROUTER/CONFIG/INTERFACES (ETH)/SETUP/PRIMARY IP menu, select the SUBNET MASK option

and press <Enter>.

Enter the appropriate Subnet Mask.

6. From the ROUTER/CONFIG/ROUTES menu, select the DEFAULT GATEWAY option and press <Enter>.

Enter the appropriate Default Gateway.

7. Escape out to the ROUTER menu and log off by pressing <Ctrl + L>.

Follow-up Procedures

Once this procedure is complete, return to the procedure which referred you to this DLP and continue with

the tasks indicated there.

Perform Steps Below in the Order Listed

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 161 162

Keine Kommentare

ADTRAN TA 544 Bedienerhandbuch Seite 110