ADTRAN TA 544 Bedienerhandbuch PDF herunterladen (Seite 51)

Total Access 544R System Manual Section 4 SHDSL RCU ATM User Interface Guide

SYSTEM UTILITY > TERMINAL MODE

Selecting the terminal mode gives the user a command-line prompt to perform utilities such as pings,

traceroutes, resets, firmware updates, configuration, and more.

TERMINAL MODE can also be accessed by

using the shortcut keys

CNTRL T from other menu screens. From this command-line prompt, you can:

• Perform a reset with the command "reset"

• Perform a factory restore with the command "factory_reset"

• Configure the unit. The unit has the ability to download a text file which contains the configuration of

the entire unit. This configuration may then be altered in a text editor, and then uploaded to a unit.

• Debug and troubleshoot. This function would be carried out with the assistance of ADTRAN Technical

Support.

• Start and stop the fail-safe timer for the auto-config feature.

• Perform a firmware upgrade via TFTP.

upgrade_firmware hostname filename

• Use the save command to write the entire configuration to flash.

• Display the unit’s MAC address with the command mac

• Perform a ping or extended ping. Syntax is:

ping hostname/address [repeat xx] [size xx] [timeout xx] [source xx] [noNat]

Options:

repeat <repeat count> Number of pings to send (default 5)

size (datagram size) Range is 40-1500

timeout (seconds) Timeout in seconds (range 1-10)

source (address or name) Source address or interface name to use

noNat Do not NAT the ping packet

Options may be entered in any order and may be truncated.

Valid interface names are eth0, fdl0, ppp0, fr0, fr1, etc.

Example usage: ping 10.0.0.5 r si 1500 so eth0 n

This will ping with a repeat count of 10. The datagram size is 1500 bytes, and the source address

used in the ping packet will be the ethernet IP address. The “noNat” option has been specified, so

if NAT is enabled, this packet will NOT be translated.

• Perform a traceroute or extended traceroute. Syntax is:

traceroute hostname/address [hops xx] [timeout xx] [retries xx] [source xx] [noNat]

Options:

hops <hops count> Max number of hops (default 30)

timeout <seconds> Timeout in seconds (default 3)

retries <seconds> Number of retries per hop (default 3)

source <address or name> Source address or interface name to use

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 161 162

Keine Kommentare

ADTRAN TA 544 Bedienerhandbuch Seite 51