ADTRAN TA 544 Bedienerhandbuch PDF herunterladen (Seite 26)

Section 3 Network Turnup Procedure Total Access 544R System Manual

1. INTRODUCTION

This section discusses the unit installation process.

2. TOOLS REQUIRED

The tools required for unit installation are:

• Screws (customer-provided for wallmount installation)

• Screwdriver (for wall or rackmount installation)

3. UNPACK AND INSPECT THE SYSTEM

Each unit is shipped in its own cardboard shipping carton. Open each carton carefully and avoid deep

penetration into the carton with sharp objects.

After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in

transit, immediately file a claim with the carrier, and then contact ADTRAN Customer Service (see the

contact information in the front of this manual).

Contents of ADTRAN Shipment

Your ADTRAN shipment of the Total Access 544R includes the following items:

• Mounting Instructions (P/N 64200600L1#T-19A)

•CD

• Cable Tie (P/N 3292032)

• Silver Satin Cable (P/N 3127004)

• Four Rubber Feet (P/N 3270BF003)

• Power Cord (P/N 3127009)

• 2 Mounting Brackets (P/N 3265421@C)

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

During installation, power should be the last connection made.

Electronic modules can be damaged by static electrical discharge. Before handling

modules, wear an antistatic discharge wrist strap to prevent damage to electrical

components. Place modules in antistatic packing material when transporting or storing.

When working on modules, always place them on an approved antistatic mat that is

electrically grounded.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 161 162

Keine Kommentare

ADTRAN TA 544 Bedienerhandbuch Seite 26