ADTRAN TA 544 Bedienerhandbuch PDF herunterladen (Seite 69)

Total Access 544R System Manual Section 4 SHDSL RCU ATM User Interface Guide

ROUTER > CONFIG > INTERFACES (ETH)> SETUP

Configure the Ethernet addressing, RIP, and Proxy ARP from this menu.

PRIMARY IP

This is used to setup the IP addresses for the LAN on the unit.

IP ADDRESS

The IP address assigned to the unit's Ethernet port is set here. This address must be unique within

the network. Default is

10.0.0.1.

SUBNET MASK

This is the IP network mask that is to be applied to the unit's Ethernet port. Default is

255.255.255.0.

RIP

Use this menu to enable RIP on the LAN interface.

VERSION

Enables or disables RIP and specifies the RIP protocol. Choices are; OFF (which disables

RIP),

V1 (RIP Version 1) or V2 (RIP Version 2). The default is OFF.

METHOD

Specifies the way the RIP protocol sends out its advertisements. The following options are

available:

SPLIT HORIZON (DEF)

Only routes not learned from this circuit are advertised.

POISON REVERSE

All routes are advertised, but the routes learned from this port

are “poisoned” with an infinite metric. The default is Split

Horizon.

DIRECTION

Allows the direction at which RIP advertisements are sent and received to be specified.

TX AND RX (DEF)

RIP advertisements are periodically transmitted and are listened

to on this port.

TX ONLY

RIP advertisements are periodically transmitted but are not

listened to on this port.

RX ONLY

RIP advertisements are listened to on this port, but are not

transmitted on this port.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 161 162

Keine Kommentare

ADTRAN TA 544 Bedienerhandbuch Seite 69