ADTRAN TA 544 Bedienerhandbuch PDF herunterladen (Seite 38)

Section 4 SHDSL RCU ATM User Interface Guide Total Access 544R System Manual

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > FAR-END IP ADDRESS

This is the far-end IP address used for the FDL management. The FDL is a separate IP network from the

customer data that is configured under the Router menus. The factory default is

0.0.0.0.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > LEARN ADDRESS

When set to ON, the destination address on each received packet is assumed to be the FDL interface

address. A 255.255.255.252 netmask is used, which determines the far-side address as well (since there can

be only two addresses on a subnet with that netmask). When set to

OFF, the user must input the IP address

assigned to the FDL interface. Default is

ON.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > ACCEPT ALL SNMP

When set to ON, SNMP gets/sets received over the FDL link are always accepted regardless of the

community table. When set to

OFF, the community table is searched for valid manager IP addresses and the

SNMP traffic is rejected if a match is not found. Default is

ON.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > MTU

Maximum Transmit Unit allows the user to set the largest acceptable IP packets that will be transmitted

before configuration takes place. The range is 64 to 256 kbps. The default is

256 KBPS.

SYSTEM CONFIG > SYSLOG

Configure the unit Syslog client for use with a Syslog server (supplied with ADTRAN Utilities or available

on most Unix platforms) from this menu.

SYSTEM CONFIG > SYSLOG > SYSLOG IP

IP address of the syslog daemon to which log message should be sent. The values must be dotted decimal

notation.

SYSTEM CONFIG > SYSLOG > SYSLOG FORMAT

The SYSLOG FORMAT is the format of log messages. "ADTRAN" uses a format that is compatible with

Adtran Utilities and forces the Syslog Facility to LOCAL0.

UNIX uses the traditional Unix format and

reports at the configured facility level.

For additional information, reference RFC3164: The BSD Syslog Protocol.

Adtran Utilities may malfunction if messages are received in the Unix format.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 161 162

Keine Kommentare

ADTRAN TA 544 Bedienerhandbuch Seite 38