ADTRAN TA 544 Bedienerhandbuch PDF herunterladen (Seite 147)

Total Access 544R System Manual Section 5 DLP-15

Upgrade From A.03 to A.03.9X (Transition Build) to A.04

1. Upgrade the firmware from A.03 to A.03.9X (Transition Build) firmware. See DLP-7 or DLP-8 for

instructions on how to perform this upgrade.

2. Once the upgrade to A.03.9X is complete, immediately upgrade the unit to A.04. See

DLP-7 or DLP-8 for instructions on how to perform this upgrade.

Upgrade From A.03 to A.04 Directly

1. Upgrade the firmware from A.03 to A.04 firmware. See DLP-7 or DLP-8 for instructions on how to

perform this upgrade.

2. The unit must then be factory defaulted: by one of the following methods:

• Select SYSTEM UTILITY > TERMINAL MODE. At the > prompt, type fac. You will then see “Restore

Factory Defaults and Reset Unit? (press 'y').” Press the Y key to confirm default. The unit will then

automatically reset.

• If connected to the

CRAFT port, power reset the unit and then restore power to the unit while

holding down the F key. You will then be prompted to confirm the factory default.

3. Reconfigure the unit for the specific application.

Follow-up Procedures

Once this procedure is complete, return to the procedure which referred you to this DLP and continue with

the tasks indicated there.

Perform Steps Below in the Order Listed

Upgrading from A.03 to A.03.9X (Transition Build) to A.04 will save the unit's

configuration.

Upgrading from A.03 to A.04 directly (or from A.04 to A.03 directly) will erase the unit's

configuration.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 161 162

Keine Kommentare

ADTRAN TA 544 Bedienerhandbuch Seite 147