ADTRAN Stub Routing Spezifikationen PDF herunterladen (Seite 147)

100

101

Command Reference Guide Global Configuration Mode Command Set

cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>

Use the cross-connect command to create a cross-connect map from a created tdm-group on an interface

to another physical or virtual interface.

Changing cross-connect settings could potentially result in service interruption.

Syntax Description

<#>

Number descriptor or label for identifying the cross-connect (useful in systems

that allow multiple cross connects)

Specifies the interface (physical of virtual) on one end of the cross-connect

Valid interfaces include: T1 (t1 1/1), DDS (dds 1/1), serial (ser 1/1), and shdsl

(shdsl 1/1)

Used when a physical interface is specified in the <from interface> subcommand

(For example: specifying the T1 port of a T1 module would be t1 1/1).

<tdm-group#>

Specifies which configured tdm-group to use for this cross-connect. This

subcommand only applies to T1 physical interfaces.

Specifies the interface (physical or virtual) on the other end of the cross-connect.

Used when a physical interface is specified in the <to interface> subcommand.

(For example, specifying the primary T1 port of a T1 module would be t1 1/1).

Default Values

By default, there are no configured cross-connects.

Command Modes

(config)# Global Configuration Mode required

Command History

Release 1.1 Command was introduced

Functional Notes

Cross-connects provide the mechanism for connecting a configured virtual (layer 2) endpoint with a physical

(layer 1) interface. Supported layer 2 protocols include frame relay and point-to-point protocol (PPP).

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

ADTRAN Stub Routing Spezifikationen Seite 147

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ADTRAN Stub Routing