ADTRAN Stub Routing Spezifikationen PDF herunterladen (Seite 548)

100

101

Router (OSPF) Configuration Command Set Command Reference Guide

network <ip address> <wildcard> area <area id>

Use the network area command to enable routing on an IP stack and to define area IDs for the interfaces

on which OSPF will run. Use the no form of this command to disable OSPF routing for interfaces defined

using this command.

Syntax Description

Network address <A.B.C.D>.

The wildcard mask is in an IP-address-type format and includes “don’t care” bits.

Identifier for this area. Enter as an integer (range: 0-4294967295) or an IP

address <A.B.C.D>.

Default Values

No default values required for this command.

Command Modes

(config-ospf)# Router (OSPF) Configuration Mode required

Command History

Release 3.1 Command was introduced

Technology Review

In order for OSPF to operate on an interface, the primary address for the interface must be included in the

network area

command. Assigning an interface to an OSPF area is done using the

network area

command.

There is no limit to the number of network area commands used on a router. If the address ranges defined for

different areas overlap, the first area in the

network area

command list is used and all other overlapping

portions are disregarded. Try to avoid overlapping to avoid complications.

Usage Examples

In the following example, the OSPF routing process is enabled and two OSPF areas are defined.

(config)#

router ospf

(config-ospf)#

network 192.22.72.101 0.0.0.255 area 0

(config-ospf)#

network 10.0.0.0 0.255.255.255 area 10.0.0.0

1 2 ... 543 544 545 546 547 548 549 550 551 552 553 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

ADTRAN Stub Routing Spezifikationen Seite 548

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ADTRAN Stub Routing