
Crypto Map IKE Command Set Command Reference Guide
276 © 2003 ADTRAN, Inc. 61950860L1-35D
CRYPTO MAP IKE COMMAND SET
To activate the Crypto Map IKE command set, enter a valid version of the crypto map ipsec-ike
command at the Global Configuration Mode prompt. For example:
Router>
enable
Router#
configure terminal
Router(config)#
crypto map Map-Name 10 ipsec-ike
Router(config-crypto-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 558
end on page 559
exit on page 560
All other commands for this command set are described in this section in alphabetical order.
match address <listname> on page 277
set peer <address> on page 279
set pfs [group1 | group2] on page 280
set security-association lifetime [kilobytes | seconds] <value> on page 281
set transform-set <setname1 - setname6> on page 282
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the NetVanta 3000 Series System Manual CD provided with
your unit.
Kommentare zu diesen Handbüchern