ADTRAN Stub Routing Spezifikationen PDF herunterladen (Seite 291)

100

101

Command Reference Guide Ethernet Interface Configuration Command Set

ETHERNET INTERFACE CONFIGURATION COMMAND SET

To activate the Ethernet Interface Configuration command set, enter the interface ethernet command at

the Global Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface ethernet 0/1

Router(config-eth 0/1)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 556

description on page 557

do on page 558

end on page 559

exit on page 560

shutdown on page 561

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 292

arp arpa on page 295

bandwidth <value> on page 296

bridge-group <group#> on page 297

bridge-group <group#> path-cost <value> on page 298

bridge-group <group#> priority <value> on page 299

bridge-group <group#> spanning-disabled on page 300

crypto map <mapname> on page 301

full-duplex on page 303

half-duplex on page 304

ip commands begin on page 305

mac-address <address> on page 322

mtu <size> on page 323

snmp trap on page 324

speed <rate> on page 325

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

ADTRAN Stub Routing Spezifikationen Seite 291

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ADTRAN Stub Routing